plot series < enable | disable > This command can be used to enable or disable series plot mode. A series plot is one of a set of plots that are of fairly narrow mainscan width, and positioned next to each other on the media. Typically, one parameter is modified for each plot, so that the whole series can be analysed to detect the effect that changing the one parameter has on the output. When series plotting is enabled, the carriage is not returned to the original edge search start position after a plot, but instead is moved to the next plot position as determined by the inter-plot gap. This continues for each subsequent plot until series plotting is disabled. Gravure Japanese_Newspaper_OEM_Engine Lotem_400_Fiber_Head_Machine Lotem_800_Fiber_Head_Machine Lotem_Quantum Magnus_400 Magnus_800 Magnus_VLF Slave_MCE_Firmware Thermoflex Think_Motion_Controller Trendsetter_400/800 Trendsetter_NEWS Trendsetter_Series_4 Series plots are disabled by default. This command affects both test plots and workstation plots. Series plotting should be disabled when performing workstation plots. This command is available. Expert 11-Jun-2001 ..\..\ShowAllErrors.htmFirmware 1 Error Index ..\..\ShowAllCommands.htmFirmware 1 Command Index ..\..\ShowAllParameters.htmFirmware 1 Parameter Index Updated: Thu Jul 17 07:25:17 2008 PST